Short Rail Photovoltaic Mounting System
The Taborsky SHORT RAIL photovoltaic mounting system has been specifically designed for TABORSKY trapezoidal profiles.
The short rail system is mounted on the peaks of the trapezoidal profiles. The short rails are pre-drilled to fit the most common TABORSKY roof profiles. The short rails are attached to the profile peaks with 4 special fastening screws. The trapezoidal profiles should have a thickness of at least 0.75 mm.
The number of short rails per PV panel depends on the structural loads (wind and snow) and must be checked by a structural engineer in each individual case.
The advantages of the TABORSKY SHORT RAIL PV mounting system:
- Specifically designed for TABORSKY trapezoidal profiles and suitable for the following profiles:
TR20/125, TR35/207, TR40/183, TR45/333, TR50/250, TR85/280, TR85/280S, TR150/280, TR160/250 - Optimal air circulation under the PV panels
- Quick and easy installation on the peaks of the trapezoidal profiles
- EPDM seal applied to the short rails
- Rust-proof system made of aluminum and stainless steel
- Middle and end clamps black anodized
- Integrated grounding pins in middle and end clamps
Compatibility and Installation
The short rail mounting system is compatible with almost all commercially available PV panels with a thickness of 30 mm (35 mm also available upon request).
The short rails are suitable for roofs with a pitch of 0-60°.
The following installation schemes can be implemented, with option 1 being preferable:
|
|
The TABORSKY PV short rail system consists of the following components:
|
pre-drilled 
|
black anodized with pins 
|
|
black anodized with pin 
|
Mounting screws 
|