Trapezoidal sheet edging tool
New in Taborsky accessories: the trapezoidal sheet edging tool with various interchangeable attachments.
For proper processing of trapezoidal roof profiles, the bottom of the profile can be bent up in the ridge area on the one hand and the bottom of the profile can be bent down in the eaves area on the other.
Bending the bottom of the profile up at the ridge can prevent the penetration of wind and driving rain. Bending it down at the eaves prevents the risk of water running back at the drip edge. (Attention: important for profiles with anti-condensation coating)
The basic device with the appropriate attachments can be used on the following trapezoidal profiles:
- Attachment T106 for TR 35/207, TR 37/200 and TR 40/183
- Attachment T119 for TR 50/250
- Attachment T258 for TR 45/333
Overview Accessories
- Antenna passage for roofing tile
- Anti-condensation DR!PSTOP
- Timber & steel attachment
- Coils and sheet metal
- Sealing tape
- Passage set for roofing tile
- Ridge caps for roof tile
- Ridge caps, edged and profiled
- Ridge vents
- Taborsky dome
- Translucent panels, 3 m and 6 m
- Profile fillers
- Snow guard set for roofing tile
- Snow protection
- Protective film
- Trapezoidal sheet edging tool
- Eaves ventilation element for roofing tile
- Angled snow protection
- Y-piece for roofing tile
- Toothed sheets
- Toothed sheets, perforated